Performing Cleaning Independently - Oki IP-5630 User Manual

Missing dots are still found even after the cap cleaning...
š If you still see missing dots even after the cap cleaning above, check the caps visually and remove foreign matters and
ink stains from them with a cleaning swab dampened with cap cleaning liquid.

Performing cleaning independently

1
PRINTER READY
01: PAPER / 1626mm
2
PH. RECOVERY
2 NORMAL
3
>NORMAL
BOTTLE IS EMPTY?
4
PH RECOVERING
REQUIRED TIME
Y:YY: Required time
The cleaning is complete.
PRINTER READY
01: PAPER / 1626mm
XXXXXXX
Y:YY
Press the PH.RECOVERY button.
You can perform PH recovery in the following situations.
- When the printer is idle online
- When the printer is offline
- During printing
- When the printer is in pause
Press the OK button.
š NORMAL (cleaning) is not displayed if a given length
of media has been printed since the last cleaning
operation.
In this case, execute STRONG (strong cleaning).
(See Strong cleaning on
š A check of the safe scanning sensors may be
performed during cleaning. In such a case, the
following message is displayed on the panel.
CHECKING SAFE SCAN
FUNCTION. PLS WAIT.
Press the OK button.
An error occurs if the waste ink bottle is full. Follow the
instructions to replace the waste ink bottle.
page 102 Waste ink bottle check and
(
replacement)
Start the print head cleaning.
Print head cleaning takes several minutes.
When the cleaning starts, the required time is displayed and
the time is counted down every 10 seconds.
Online idle: Switches to online state
Offline: Stays offline
Printing: Resume printing
In pause: Stays in pause
page 226.)
115
Maintenance