Table of Contents
Advertisement
7
OPEN COVERS AND
CHECK PRINT HEADS
8
9
132
Maintenance
Sensors for automatic print adjustment
①
②
③
④
Open the front cover, and then the
maintenance area cover.
Clean the surface of the sensors for automatic
print adjustment with a cleaning swab.
Three holes are aligned on the bottom plate
at the carriage left side.
There is a sensor inside each hole. Clean them
by softly wiping their surface with a cleaning
swab to remove the ink.
Note
‹ Do not put any substances onto the cleaning swab as it
may cause the sensors to malfunction.
Clean the areas around the ionizer nozzles
with a cleaning swab. The ink adheres
principally onto four areas ((1) to (4) in the
figure) inside the ionizers cover plate at the
bottom of the carriage.
Wipe off any ink from these areas with a
cleaning swab.
Advertisement
Table of Contents
