Table of Contents
Advertisement
When an error occurs with automatic configuration
If one of the following errors occurs when executing automatic configuration, try manual configuration or perform
the checks and the actions explained below.
INSTALL WIDER MEDIA
* Automatic configuration is not performed. Nozzle map settings from before the execution are maintained.
Meaning
Media of less than 762 mm (30 inches) is used.
Items to be checked
Check that the media is not less than 762 mm (30
inches).
MANUALLY CONFIGURE
NOZZLE MAPPING
* Automatic configuration is not performed. Nozzle map settings from before the execution are maintained.
Meaning
The amount of light received by the sensors did not reach the reference level.
Items to be checked
Check that the sensors for automatic print
adjustment are not covered with ink mist.
Check that the media is clean.
Check that the media is not wrinkled.
Check that you are not using a media type with a
light reflection rate too low.
MANUALLY CONFIGURE
NOZZLE MAPPING
* Automatic configuration is not performed. Nozzle map settings from before the execution are maintained.
Meaning
The amount of light received by the sensors exceeds the reference level.
Items to be checked
Check that the media is not wrinkled.
Check that no external light reaches the sensors.
Check that you are not using a media type with a
light reflection rate too high.
100
Maintenance
Use media of 762 mm (30 inches) or larger with automatic configuration.
Otherwise use manual configuration.
1
Clean the sensors for automatic print adjustment.
(See Cleaning around the ionizers and the sensors for automatic print
adjustment on
Feed the media until you reach a clean section.
Reinstall the media or feed the media until you reach a section without wrinkles.
Automatic print adjustment may not be possible with some media types. In
such a case, use manual print adjustment.
2
Reinstall the media or feed the media until you reach a section without wrinkles.
Block the external light or change the printer installation location.
Automatic print adjustment may not be possible with some media types. In
such a case, use manual print adjustment.
Corrective measures
Corrective measures
page 131.)
Corrective measures
Advertisement
Table of Contents
