Table of Contents
Advertisement
CONTENTS OF THE PACKING
1.7 INSTALLATION ENVIRONMENT
The control rack must be installed in a suitable environment in order to allow proper air flow passage and
correct housing of the cables.
TM
Vlase
is an air cooled marking system: an adequate air flow is necessary to guarantee correct cooling of
the system. Install the rack so that air flow is not obstructed. Moreover, do not install it near a heat source.
Clean the air filter when it is dirty. If the air filter is dirty, insufficient air-flow might not ensure correct cooling
and might stop the marking operation. Clean or replace the air filter periodically.
WARNING!
DO NOT place heavy objects on top of the rack!
In order to have the marking system operating in safety mode (see Appendices for more details) we
recommend installing the marking system as shown in the figure below in order to limit the laser output area.
To obtain a good marking quality, and to avoid decreasing system life time, we recommend a ventilation or
vacuum system in a protection box to limit dust due to the marking phase.
Figure 8: Rack installation environment.
Figure 9: Safety mode example.
1
15
Advertisement
Chapters
Table of Contents
