Use And Operation; Turning On Sequence; Figure 54: Power On; Figure 55: Status Led Display - Datalogic VLASE IR 1PWX-TLS2 User Manual

4

4 USE AND OPERATION

4.1 TURNING ON SEQUENCE

Before turning on the marking system, be sure that the system is connected as previously described. Check
presence of voltage power supply connection, interlock connector and Command Box connector. Check that
KEY and ENABLE commands on the rack front panel are disabled (see Figure 19 and Figure 20).
ST
1 : turn on the main switch at the back of the control rack:
EXT_KEY
EXT_ENABLE_A
EXT_ENABLE_B
During booting-up, the status LED on the rack front panel will be blinking green.
Wait until booting-up finishes. The status LED on the rack will be steady green.
50

Figure 54: Power on.

SIGNAL

Figure 55: Status LED display.

VLASE
STATUS
OFF
OFF
OFF
TM
IR