Connecting The Optical Fiber To The Control Rack; Figure 31: Removing The Cover Plate From The Rack; Figure 32: Passing The Optical Fiber Through The Cable Gland - Datalogic VLASE IR 1PWX-TLS2 User Manual

INSTALLATION AND SET UP

3.1.4 CONNECTING THE OPTICAL FIBER TO THE CONTROL RACK

Follow the steps listed here below to connect the optical fiber to the control rack:
1) unscrew the four screws holding the cover plate on the rack.
2) insert the optical fiber into the cable gland without removing its protection cap.
WARNING!
The insertion of the optical fiber is a delicate operation. You must make sure that the optical fiber is
protected by its cap during insertion through the cable gland to avoid damaging or dirtying it.

Figure 32: Passing the optical fiber through the cable gland.

Figure 31: Removing the cover plate from the rack.

3
37