Figure 56: Enable Command Key; Figure 57: Status Led Display - Datalogic VLASE IR 1PWX-TLS2 User Manual

USE AND OPERATION
ND
2 : activate the command KEY, by rotating it clockwise:
EXT_KEY
EXT_ENABLE_A
EXT_ENABLE_B
When the KEY command is enabled, the status LED on the rack will be blinking orange for about 20 seconds
(laser source warm-up).
Wait until laser source warm-up finishes. The status LED on the rack will be steady orange.

Figure 56: Enable command KEY.

SIGNAL

Figure 57: Status LED display.

STATUS
ON
OFF
OFF
4
51