Table of Contents
Advertisement
1
1.4 TRANSPORT
The marking system needs to be moved in order to proceed to its positioning and wiring. The marking
system can't be lifted up and moved by a single person.
WARNING!
To avoid damaging or breaking the optical fiber, never subject it to a bending radius below the limits
specified in the technical specification table.
WARNING!
TM
Vlase
is a delicate optical laser marking system, avoid damaging it with shock and vibrations.
WARNING!
Be extremely careful to not damage the fiber optic cable between resonator and rack.
1.5 ON MOISTURE CONDENSATION
If the marking system is brought directly from a cold to a warm location, moisture may condense inside or
outside the marking system. This moisture condensation may cause a malfunction of the marking system.
If moisture condensation occurs
Turn off the marking system and wait about 1 hour for the moisture to evaporate.
Note on moisture condensation
Moisture may condense when you bring the marking system from a cold place into a warm place (or vice
versa) or when you use the marking system in a humid place.
How to avoid moisture condensation
When you bring the marking system from a cold place into a warm place, put it in a plastic bag and seal it
tightly. Remove the bag when the air temperature inside the plastic bag has reached the ambient
temperature (after about 1 hour).
12
Figure 3: Transport.
TM
VLASE
IR
Advertisement
Chapters
Table of Contents
