Connecting The Air Hoses To A Single Hopper - Conair Carousel Plus D Series User Manual

C o n n e c t i n g t h e A i r H o s e s t o a S i n g l e
H o p p e r
( D 1 3 0 0 - 5 0 0 0 )
Depending on how your dryer was configured, using the two flexible hoses or the hard
piping kit provided, connect the inlet of the Heater Pack and outlet of the drying hopper
to the dryer. Make sure the dryer is located as close as possible to the hopper (10 ft {3.05
m} of hose supplied).
1
Attach one hose (or pipe) from the re-
turn air inlet, located on top of the
dryer, to the outlet of the hopper.
2
Attach one hose (or pipe) from the de-
livery air outlet, located on top of the
dryer, to the inlet of the Heater Pack.
3
Secure hoses with clamps. The hose clamp should be se-
cured at least 1/4 in. {0.64 cm} from the end of the inlet or outlet tube.
0
NOTE: If connecting
your dryer to a cyclone
or dust collector, your
installation may very
slightly. Refer to the
instruction that came
with your equipment
(cyclone, dust collector,
heater pack) for more
information.
Return Air
Inlet
Delivery Air
Outlet
0
NOTE: Do not allow the
flexible hoses to kink or
crimp.
0
NOTE: Inlet and outlet
locations may be dif-
ferent on your dryer.
Refer to the labeling
on your dryer.
I n s t a l l a t i o n l 3 - 9