Connecting The Setback Rtd Probe; C O N N E C T I N G T H E S E T B A C K R T D P R O B E - Conair Carousel Plus D Series User Manual

C o n n e c t i n g t h e D e l i v e r y A i r R T D P r o b e
The delivery air RTD probe monitors the temperature of the drying air as it enters the hopper.
If the probe is not installed correctly, temperature readings will be inaccurate.

C o n n e c t i n g t h e S e t b a c k R T D P r o b e

( O p t i o n a l )
1
Insert the probe in the hopper outlet at the top of the hopper. The end of the probe must
not touch the walls of the inlet. The tip of the probe should be approximately in the center
of the tube. Tighten the compression fittings to lock the probe in place.
2
Plug the probe's cable into the receptacle labeled setback on the left side of the elec-
trical enclosure. Hand tighten the connector. Coil any excess cable and secure it with a
wire tie.
C o n n e c t i n g t h e P r o c e s s P r o t e c t i o n R T D
( O p t i o n a l )
1
Insert the probe into the 1/8 inch NPT coupling on heater manifold (before the hopper
inlet). The manifold will be threaded for the process protection connection.
2
Plug the probe's cable into the receptacle labeled Process Protection on the left side
of the electrical enclosure. Hand tighten the connector. Coil any excess cable and secure
it with a wire tie.
1
Insert the probe at the inlet to the
hopper. The end of the probe must not touch the
walls of the inlet. The tip of the probe should be ap-
proximately in the center of the tube. Tighten the
compression fittings to lock the probe in place.
Setback RTD
2
Plug the probe's cable into
the receptacle labeled
process on the left side of
the electrical enclosure.
Hand tighten the connector.
Delivery Air RTD
Coil any excess cable and
secure it with a wire tie.
Central
When configured as a
central dryer, moni-
toring the drying air
temperature is not
necessary since there
is no delivery air
heater in the system.
Therefore, installa-
tion and connection
of the RTD probe
and/or setback probe
is not applicable.
I n s t a l l a t i o n l 3 - 5