Additional Alarms - Conair Carousel Plus D Series User Manual

Problem
Control Not Ready, Please
Check Alarm - Displayed
when the "Start" button is
pushed during any active
alarm. (Passive or Shutdown)
Lost Comm w/ Ctrl Bd - Indi-
cates there is a problem in the
communication between the
control board and the display
board.
Control displays --------- where
parameters should be seen.
Start / Stop buttons are not ac-
tive.
Alarm horn and light are ac-
tive, but no alarm displays on
the HMI.
There is no software revision
value at the bottom of the
home screen.
6 - 2 2 l Tr o u b l e s h o o t i n g
A d d i t i o n a l A l a r m s
Along with the alarm indicators, you may encounter additional messages that indi-
cate a problem within the control.
Possible cause
The dryer will continue to run if there is
a passive alarm, however it will not start
if there is a active alarm.
Loose or improperly connected wire.
Improper dip switch setup on control
board.
Defective display or control board.
A sensor is disconnected or malfunction-
ing.
The dryer is currently in a stage where
stopping or starting the dryer is not avail-
able.
Loose connection or wiring is not cor-
rect.
Dryer board failure.
Loose connection or wiring is not cor-
rect.
Dryer board failure.
Solution
Push the acknowledgement button to
identify the alarm, and address it as nec-
essary.
Check wiring between control board and
display board.
Check dip switch setup on control board.
Replace boards as a set.
Check and verify that all sensors are con-
nected correctly.
Wait for dryer to complete the process,
and buttons will become active.
Verify that wiring is correct and that con-
nections are good.
Cycle power to the dryer control board.
Call Conair Service.
Conair's Instant Access 24/7 Parts and
Service number is 800-458-1960.
Outside the U.S., dial 814-437-6861.
Verify that wiring is correct and that con-
nections are good.
Cycle power to the dryer control board.
Call Conair Service.
Conair's Instant Access 24/7 Parts and
Service number is 800-458-1960.
Outside the U.S., dial 814-437-6861.