Conair Carousel Plus D Series User Manual page 175

M o u n t i n g M e t h o d 3
(Not enough overhead clearance to insert the probe
from the top of the hopper)
1
Reference the drawings at the end of this user guide and select the drawing
that reflects your installation.
Drill the appropriate hole in the
top of the hopper.
2
Drill and tap three 10-32 UNF
holes to match the screw pattern
in the adapter plates and gasket.
You can use the template in the
appendix.
3
Remove the two adapter plates from the
probe mounting assembly. Set the adapter
plates aside for use in Step 7.
4
Insert the probe and mounting
assembly through the door of the
hopper.
5
Pull the probe and mounting
assembly through the hole in the
top of the hopper. Fold the gasket
around the probe so that it will fit
through the hole.
Tools for Installation:
❒ Drill and 10-32 tap
❒ Flathead screwdriver
❒ 7/8-in. wrench
❒ 2-in. hole saw
2
2 in. (50.8 mm)
diameter probe hole
3
5
4
45°
Three 10-32 UNF
holes spaced
around a 2 3 / in.
4
(69.9 mm) diame-
ter circle
Adapter
plates
✐
(continued)
IMPORTANT: Stretch
cloth or plastic across
the inside of the hopper
to catch metal shavings
from the hole you will
drill in the top of the
hopper.
NOTE: If the angled probe is
used, the bend (dog leg) in the
probe must be oriented so that it
is angled in toward the center of
the hopper.
A p p e n d i x l C - 1 3