Conair Carousel Plus D Series User Manual page 174

IMPORTANT: Stretch
cloth or plastic across
the inside of the hopper
to catch metal shavings
from the hole you will
drill in the top of the
hopper.
✐
NOTE: The mounting
adapter kit will only be
included if the DM was
ordered as a retrofit kit.
Remove the mounting adapter
plates from the probe assem-
bly, you will not need them.
You will need the gasket.
Tools for Installation:
❒ Drill and 10-32 tap
❒ Knife
❒ Flathead screwdriver
❒ 7/8-in. wrench
✐
NOTE: If the angled probe is
used, the bend (dog leg) in the
probe must be oriented so that
it is angled in toward the center
of the hopper.
C - 1 2 l A p p e n d i x
M o u n t i n g M e t h o d 2
(Drying hopper with enough overhead clearance to
insert probe from the top of the hopper)
1
Reference the drawings at the end of this user guide and select the drawing that
reflects your installation. Drill the appropriate hole in the top of the hopper.
2
Drill and tap four 10-32 UNF
holes to match the hole pattern
in the coupling.
3
Secure the gasket and coupling to the hopper with the four 10-32 screws.
Remove any excess gasket with a knife.
4
Insert the probe through the coupling in the
top of the hopper.
5
Screw the fitting into the coupling. Tighten
with a wrench.
6
Make sure the probe is the correct size. The
probe should extend from just above the top of
the hopper into the hopper, with the tip approx-
imately in-line with the bottom
edge of the diffuser cone.
7
Push the compression sleeve into
the fitting.
8
Tighten the nut over the sleeve.
The compression sleeve will crimp the tube to
hold the probe in place. Be sure to position the
connector in such a way as to avoid interfer-
ence of the cable with the loader, etc. Use a
wrench to tighten the nut so that it covers the
threads.
9
Thoroughly clean the inside of the hopper to
remove any debris left from installation of the
probe.
1 /
in. (12.7 mm)
2
diameter center hole
2
Four 10-32 UNF
holes evenly spaced
around a 1
(38.1 mm) circle
8
7
6
5
3
1 /
in.
2
Connector
Nut
Sleeve
Fitting
Coupling
Gasket