Replacing The Desiccant Wheel Assembly - Conair Carousel Plus D Series User Manual

OFF
O
6 - 3 8 l Tr o u b l e s h o o t i n g
R e p l a c i n g t h e D e s i c c a n t W h e e l
A s s e m b l y
( D 6 0 0 - 1 0 0 0 )
When desiccant becomes clogged or contaminated, you should replace the desiccant wheel
to ensure optimum performance.
1
Stop the dryer, disconnect and lockout the main power.
2
Remove the upper and lower side panels from both sides of the
dryer.
0
NOTE: If your dryer is configured with a hard pipe kit, disconnect the hard piping from the top of
the dryer at this time.
3
Remove the top cover from the dryer by removing the securing bolts.
4
Note the position of all the hoses, RTDs, and wiring connections then remove or
disconnect these from the desiccant wheel assembly.
5
If the dryer aftercooler is being used, turn off the water supply to the aftercooler
and disconnect the water lines from the aftercooler.
6
Remove the four bolts securing the aftercooler assembly to the cabinet frame.
7
Using an overhead crane or similar appropriate lifting device, use the lifting
points provided and carefully lift the aftercooler off of the frame and remove it
from the dryer.
8
Remove the four bolts securing the desiccant wheel assembly to the dryer frame.
9
Note the orientation of the desiccant wheel assembly. Using an overhead crane or
similar device, use the lifting rings provided and lift the desiccant wheel assem-
bly out of the dryer.
(continued)