Replacing The Desiccant Wheel Motor - Conair Carousel Plus D Series User Manual

OFF
O
6 - 4 4 l Tr o u b l e s h o o t i n g
R e p l a c i n g t h e D e s i c c a n t W h e e l M o t o r
( D 6 0 0 - 1 0 0 0 )
1
Stop the dryer, disconnect and lockout the main power.
2
Remove side panels.
3
Disconnect wiring to the
motor.
4
Remove the pivot bolt se-
curing the belt tensioner
to the motor bracket. Be
sure to retain the flat wash-
ers located between the ten-
sioner and bracket.
Disconnect the spring and
remove the tensioner.
5
Remove the belt from the motor pulley, then remove the pulley from the motor.
6
Remove the screws securing the motor to the upper and lower bracket, and remove
the motor.
7
Secure the new motor to the bracket.
8
Install the pulley on the new motor, and position the belt on the pulley.
9
Connect the spring to the tensioner, then secure the tensioner to the motor bracket.
Be sure to install flat washers between the motor bracket and the tensioner.
10
Connect the wires to the motor.
11
Connect the power to the dryer. Turn the dryer on and ensure that the
wheel is rotating in the correct direction.
12
Replace the side panels.
desiccant