Test Hook-Up No. 4: Traction Pressure - Toro Reelmaster 216 Service Manual

Test Hook-up No. 4: Traction Pressure (Fig. 21)
Gauge Connection
Connect a 10,000 PSI hydraulic pressure gauge to
forward traction pressure gauge port.
TEST A: Traction Pressure
1. Make sure pump drive belt is properly adjusted and
in good condition.
2. Make sure hydraulic oil is at operating temperature.
3. Operate engine at full speed:
3600 ± 100 RPM
Reelmaster 216:
3200 ± 100 RPM
Reelmaster 216-D:
4. Attach a heavy chain to rear frame of machine and
then to something solid in shop. Engage parking brake.
CAUTION
Keep everyone clear from the front of unit
during traction system tests. Operator must
be on seat or the safety interlock will stop the
engine when the traction pedal is depressed.
5. While watching pressure gauges, slowly push traction
pedal into forward until maximum pressure is obtained.
GAUGE READING: 4000 – 4500 PSI.
Testing
1. 10,000 PSI hydraulic pressure gauge
Page 5 - 22
Rev. A
1
Figure 21
®
Reelmaster 216/216-D