Installing Cutting Units (Fig. 12)
(Floating Cutting Units)
1. Slide a thrust washer onto lift arm pivot rod.
2. Slide cutting unit carrier frame onto pivot rod and
secure with a flat washer, lockwasher and capscrew.
Installing Cutting Units (Fig. 13)
(Fixed Cutting Units)
1. Slide a thrust washer onto lift arm pivot rod.
2. Slide cutting unit support onto pivot rod and secure
with a flat washer, lockwasher, and capscrew.
3. Front cutting units should be parallel to front wheels.
To adjust, loosen capscrews securing supports to cut
ting units, adjust cutting units until parallel, then, re
tighten screws.
®
Reelmaster
216/216-D
Page 9 - 13
Figure 12
1. Thrust washer
2. Carrier frame
3. Flat washer, lockwasher, capscrew
Figure 13
1. Thrust washer
2. Cutting unit support
3. Flat washer, lockwasher, capscrew
Service and Repairs