4. Lift out the cylinder block assembly (Item 5). The
pistons may come out of the cylinder block. There is no
special orientation of piston to bore that needs to be
maintained. Do not attempt to disassemble the spring
and other parts from the center bore of the cylinder
block. The entire cylinder block assembly (Item 5)
should be replaced if any of its components are dam-
aged.
Repairs
5
39
Figure 37
5. Visually inspect wear surfaces of valve plate, cylinder
block and slippers for damage. Check to be sure pistons
are free in bores.
6. Remove thrust plate (Item 39) from counterbore in
face of swashplate (Item 37). Visually inspect both sides
for damage and flatness.
Page 5 - 34
8
Reelmaster
®
216/216-D