Troubleshooting (Reelmaster 216-D); Starting Problems - Toro Reelmaster 216 Service Manual

Starting Problems (continued)
Condition
________________________________________________________________________________________________________________________________________________________
Nothing happens when start at-
tempt is made.
®
Reelmaster 216/216-D
Possible Cause
Battery is dead.
Loose or corroded battery cables.
Loose or corroded ground.
"Engine" fuse open.
Fusible link open.
Temp. switch or relay faulty.
Temp relay wiring loose, corroded
or damaged.
Traction neutral switch out of ad­
justment or faulty.
Traction neutral switch wiring
loose, corroded or damaged.
Cutting unit clutch switch engaged
or faulty.
Cutting unit clutch switch wiring
loose, corroded or damaged.
Ignition switch faulty.
Ignition switch wiring loose, cor­
roded or damaged.
Start relay faulty.
Start relay wires loose, corroded or
damaged.
Starter solenoid wiring loose, cor­
roded or damaged.
Starter solenoid faulty.
Page 6 - 15
Correction
Charge battery. Replace battery if
it will not hold a charge.
Clean and tighten or repair as
necessary.
Check fuse and replace if fuse is
open. If fuse burns out often, find
and correct cause.
Replace fusible link.
Test temp. switch and relay. Re­
place if faulty.
Repair wiring.
Test switch and replace if faulty.
Make sure wires are connected
to "COMMON" and "NORMALLY
OPEN" (N.O.) terminals.
Repair wiring.
Make sure switch is OFF. Test
switch and replace if faulty.
Repair wiring.
Test ignition switch. Replace if
faulty.
Repair wiring.
Test start relay. Replace if faulty.
Repair wiring.
Repair wiring.
Replace starter.
Troubleshooting
(Reelmaster 216-D)