Toro Reelmaster 216 Service Manual page 53

Adjusting Traction Pedal
If traction pedal contacts footrest when pushed fully
forward or you cannot get maximum forward traction
speed, an adjustment to the traction pedal linkage is
required. There should be 1/16 inch between pedal stop
cam and R.H. footrest when pedal is pushed fully
forward.
1. To expose traction rod, remove (4) screws securing
right fender (Fig. 58) to frame and remove fender.
2. Loosen jam nuts on each end of traction rod.
3. Rotate rod until required to get a dimension of
1/16 inch between pedal stop cam and R.H. footrest
when pedal is pushed fully forward.
4. Re-tighten jam nuts securing traction rod adjustment.
5. The stop for reverse travel (under pedal) may be
adjusted for slower travel. Speeds in excess of 3 MPH
are not recommended.
®
Reelmaster 216/216-D
(Fig. 28, 29)
(Reelmaster 216-D)
Page 5 - 27
2
Figure 28
1. Right fender
2. Fender mounting screws
1
Figure 29
1. Traction rod
Adjustments
1