9. Lubricate thrust plate (Item 39) with clean hydraulic
oil and insert in counterbore of swashplate.
10. Assemble cylinder block parts if necessary and
lubricate with clean hydraulic oil. There is no special
orientation of piston to bore that needs to be maintained.
11. Place the housing assembly in a horizontal position.
Repairs
5
39
Figure 41
12. Slide cylinder block assembly (Item 5) over shaft and
engage spline. Be certain that pistons and thrust plate
remain in place. When properly installed a slight spring
tension can be felt when pushing on cylinder block.
13. Lubricate exposed face of cylinder block with clean
hydraulic oil.
Page 5 - 38
8
Reelmaster
®
216/216-D