Toro Reelmaster 216 Service Manual page 129

Factor
___________________________________________________________________________________________
8. Height of cut.
________________________________________________________________________________________________________________________________________________________
9. Rear roller parallel to reel.
________________________________________________________________________________________________________________________________________________________
10. Front roller adjustment.
________________________________________________________________________________________________________________________________________________________
11. Roller scraper and comb adjustment.
________________________________________________________________________________________________________________________________________________________
12. Stability and position of bedbar.
________________________________________________________________________________________________________________________________________________________
13. Number of reel blades/reel speed.
________________________________________________________________________________________________________________________________________________________
14. Cutting unit alignment.
________________________________________________________________________________________________________________________________________________________
15. Roller condition
®
Reelmaster 216/216-D
Possible Problem/Correction
All cutting units set at same height of cut. Bench set
height of cut and actual (effective) height of cut are
different. Effective height of cut depends on cutting
unit weight, counterbalance spring adjustment, cut­
ting unit accessories and turf conditions.
Check and adjust as necessary.
Check and adjust as necessary.
Set scraper for 1/32 in. clearance from roller. Set
comb the same on all cutting units for height of cut
and turf conditions. Must be same height at both
ends of comb.
Check bedbar bushings and nylon flange bushings
for wear or damage and replace if necessary.
Check adjustment knob to make sure detent holds
adjustment. Repair if necessary.
Check to make sure adjustment knob/pivot assembly
is centered in bedbar arm yoke so that an equal gap
exists on each side of pivot housing before pivot
screws are installed. Make sure bedknife adjustment
knob/pivot assembly is held firmly in place between
bedbar arm yoke.Tighten pivot set screws if
necessary.
Use cutting unit model with correct number of blades
and proper pulley size for clip frequency and opti­
mum height of cut range.
Check alignment on all cutting units. Adjust or repair
as necessary. Check lift arms for damage, binding or
bushing wear. Repair if necessary.
All rollers must rotate freely. Grease when needed or
repair bearings if necessary.
Page 9 - 5 Troubleshooting