Toro Reelmaster 216 Service Manual page 85

Verify Interlock System Operation
The purpose of the interlock system is to prevent the
engine from cranking or starting unless the traction
pedal is in NEUTRAL and the cutting unit engagement
switch is DISENGAGED. In addition, the engine will stop
when the cutting unit engagement switch is engaged or
traction pedal is depressed with the operator off the
seat.
CAUTION
The interlock switches are for the operator's
protection, so do not disconnect them. Check
operation of the switches daily to assure in ­
terlock system is operating. If a switch is
defective, replace it before operating. Regard ­
less if switches are operating properly or not,
replace them every two years to assure maxi ­
mum safety. do not rely entirely on safety
switches - use common sense!
To check interlock system operation:
1. Move machine to a wide open area free of debris and
bystanders. Raise cutting units and stop engine. En­
gage parking brake.
®
Reelmaster 216/216-D
2. Sit on seat. Move Reel Drive switch to ENGAGE
position. Try to start engine. If engine cranks, there may
be a malfunction in interlock system. Repair immedi­
ately. If engine does not crank, proceed to step 3.
3. Sit on seat. Depress traction pedal in forward and
reverse directions while trying to start engine. If engine
cranks while pedal is in forward or reverse position,
there may be a malfunction in interlock system. Repair
immediately. If engine does not crank, proceed to
step 4.
4. With cutting units in raised position, sit on seat and
start engine. Move Reel Drive switch to ENGAGE posi­
tion. Lower cutting units to ground. Cutting unit reels
should start turning when cutting units are lowered.
Raise cutting units and verify that they stop. If they do
not stop, there may be a malfunction in interlock system.
Repair immediately. If cutting units stop, proceed to
step 5.
5. While sitting on seat with cutting units in raised
position and engine running, move Reel Drive switch to
ENGAGE position. Hold on to steering wheel and raise
up off of seat. Engine should stop. If engine does not
stop, there is a malfunction in interlock system. Repair
immediately. If engine stops, seat switch is operating
correctly.
Page 6 - 13 Troubleshooting
(Reelmaster 216)