Creating The Diagram - Reer MOSAIC M1 Installation And Use Manual

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC

Creating the diagram

Once you have selected your system composition, you are ready to configure the project.
The logic diagram is created using a DRAG&DROP function:
• Select the objects as required from the windows described previously (each single object
is described in detail in the following sections) and drag it into the design area.
• Now when you select the object the PROPERTIES window is enabled, where you must fill
in the fields as required.
• When you need to set a specific numerical value with a slide (eg filter) use the left and
right arrows on your keyboard or click the sides of the slider.
• Connect the objects by moving the mouse over the required pin and then dragging it
onto the pin to be connected.
• If the scheme requires the PAN function (moving working area in the window), select the
object to move and use the arrow keys on your keyboard.
• If the scheme is very complicated and requires a connection between two elements very
far, use the "Interpage" component. The element "Interpage out" must have a name
which, invoked by the corresponding "Interpage in", allows the desired link.
(scheme
side SX)
• When you need to duplicate an object, select it and press CTRL+C / CTRL+V keys on
your keyboard or click at the right mouse button and select context menu "Copy" and
then "Paste".
Wires position: it is possible to move the wires for a better graphic visibility of the
•
scheme. To activate the function, simply place the mouse pointer and left click on the
wire to be moved.
• When you need to delete an object or a link, select it and press DEL key on your keyboard.
• Find function: (press CTRL + F) allows you to make search within the scheme based on
a search parameter. Research does not distinguish between upper and lower case.
Find Operator
8540780 • 10/07/2020 • Rev.38
Find item description
(scheme
side SX)
95