Clocking - Reer MOSAIC M1 Installation And Use Manual

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC

CLOCKING

The CLOCKING operator generates a square wave output
which period is set by the user. The output is enabled if
inputs to control output Duty Cycle.
Parameters
Time: The period can be set to between 100 ms and
1098,3 s.
Scale: The user can choose two different scales for the
time T to be set.

100 ms...60 s, step 10 ms

60,1 s...1098,3 s, step 100 ms
Duty cycle selection: Up to 7 inputs can be selected for 7 different output signal duty
cycles. Depending on the active input, the OUT clock signal has its corresponding duty
cycle. EN input must always be to 1 (TRUE).
Refer to the table below for all possible values of Duty cycle selectable by the user.
EN 10%
0 0
1 0
1 1
1 0
1 0
0
1
1 0
1 0
0
1
1 1

The circuit upstream clocking operator must ensure the presence of only one input
signal in addition to enable EN (excluded the pair 10% 80%).

The presence on EN input of high level (TRUE), generates an output signal with a duty
cycle = 50%.
8540780 • 10/07/2020 • Rev.38
Clocking has up to 7
DUTY CYCLE CHOICE
20% 30% 40%
0 0
0 0
0 0
1 0
0 1
0 0
0 0
0 0
0 0
0 0
60% 70%
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0
1
0 1 0
0 0 1
0 0 0
0 0 0
80% OUT
0 0
0 50%
0 10%
0 20%
0 30%
0
40%
0 60%
0 70%
1 80%
1 90%
203