Sagem myC-4 Site Technical Documentation page 91

REMOVING / REPLACING THE DISPLAY Proc Sheet 1 13
MODULE
myC-4 1/2
4.77 Tools :
- Cross shaped screwdriver
- Tweezers
4.78 Preliminary operation
1. Remove the battery pack ( Proc sheet 0 01).
2. Remove the back cover ( Proc sheet 1 02)
3. Remove the front cover of the lower slide ( Proc sheet 1 06).
4. Remove the back cover of the upper slide ( Proc sheet 1 07).
4.79 Removal procedure :
1. Remove the audio gasket (1) from the front cover (3)
2. Unstuck the loudspeaker (2) from the front cover (3)
3. Remove the display module (4)
4. Unsolder the loudspeaker (2) on the display module (4)
4.80 Placement procedure :
1. Flux the place of the loudspeaker (2) and solder it on the new display module (4)
2. Position the loudspeaker in its housing, respecting wires placement (5)
3. Position the audio gasket (1) on the loudspeaker (2)
4. Position the display module (4) on the front cover (3)
4.81 Further operations :
1. Replace the back cover of the upper slide ( Proc sheet 1 07).
2. Replace the front cover of the lower slide ( Proc sheet 1 06).
3. Replace the back cover ( Proc sheet 1 02)
4. Replace the battery pack ( Proc sheet 0 01).
________________________________________________________________________________________________
Ref. SCT U38 SSC DTS 0023 – Index B - February 21, 2005 Page 5-38