myC-4
4.67 Tools :
- Cross shaped screwdriver
- Soldering iron
- Solder wick
- Flat screwdriver
4.68 Preliminary operation
1. Remove the battery pack (
2. Remove the back cover (
4.69 Removal procedure :
1. Unsolder the vibrating device (1) on the equipped electronic board (2)
4.70 Placement procedure :
1. Flux the place of the vibrating device (1) and solder it on the equipped electronic board (2), respecting
the wiring sense
2. Position the vibrating device (1) in its housing
4.71 Further operations :
1. Remove the back cover (
2. Remove the battery pack (
Ref. SCT U38 SSC DTS 0023 – Index B - February 21, 2005
REMOVING / REPLACING THE VIBRATING
DEVICE
Proc sheet 0
01).
Proc sheet 1
02).
Proc sheet 1
02).
Proc sheet 0
01).
Proc Sheet 1 11
1/2
Page 5-34