Sagem myC-4 Site Technical Documentation page 89

myC-4
4.72 Tools :
- Cross shaped screwdriver
- Soldering iron
- Solder wick
- Flat screwdriver
4.73 Preliminary operation
3. Remove the battery pack (
4. Remove the back cover (
4.74 Removal procedure :
2. Unsolder the microphone (1) on the equipped electronic board (2)
4.75 Placement procedure :
3. Flux the place of the microphone (1) and solder it on the equipped electronic board (2), respecting the
wiring sense (flex PCB upward)
4.76 Further operations :
3. Remove the back cover (
4. Remove the battery pack (
Ref. SCT U38 SSC DTS 0023 – Index B - February 21, 2005
REMOVING / REPLACING THE MICROPHONE
Proc sheet 0 01).
Proc sheet 1 02).
Proc sheet 1 02).
Proc sheet 0 01).
Proc Sheet 1 12
1/2
Page 5-36