Sagem myC-4 Site Technical Documentation page 69

myC-4
4.22 Tools :
- Cross shaped screwdriver
4.23 Preliminary operation
1. Remove the battery pack (
4.24 Removal procedure :
1. On the back cover (1), unscrew the four attachment screws (2) .
2. Press the two stop pins (3) to liberate the back cover (1)
3. Lift delicately the back cover (1) up beginning by the back side
4. Remove the board to board connector (4) on the electronic board
5. Liberate the electronic board from the back cover by pressing outside the four stop pins (4)
6. Unstuck delicately the vibrating device (6) from the back cover (1)
7. Remove the back cover (1)
4.25 Placement procedure :
1. Position the vibrating device (6) into the new back cover (1)
2. Position the electronic board in its housing
3. Connect the flex on the electronic board
4. Replace the equipped back cover in its housing by engaging top hooks first.
5. screw the attachment screw (2) with 0,1 N.m torque.
4.26 Further operations :
1. Replace the battery pack (
________________________________________________________________________________________________
Ref. SCT U38 SSC DTS 0023 – Index B - February 21, 2005
REMOVING / REPLACING THE BACK COVER
Proc sheet 0 01).
Proc sheet 0 01).
Proc Sheet 1 02
1/2
Page 5-16