Dräger Isolette 8000 plus Instructions For Use Manual page 127

11.3.3 Oxygen messages
System prompt message
Not Installed
Oxygen Cal Required
Slide Out Sensor
11.3.4 Humidity messages
System prompt message
Not Installed
11.3.5 Scale messages
System prompt message
Clear Mattress
Scale Disconnect
Too Much Weight
Instructions for use Isolette 8000 plus SW 5.n
Cause
Oxygen control is attempted, but
the servo control oxygen system
is not installed.
Oxygen control is attempted, but
the servo control oxygen system
is not activated.
This message is displayed when
re-calibration is required to use
the servo oxygen control. It
occurs after 7 days of continuous
oxygen control.
This message is displayed when
the Cal button is pressed during
oxygen calibration, but the sen-
sor module is not pulled out into
the calibration position.
Cause
Humidity control is attempted,
but the humidification system is
not installed.
Humidity control is attempted,
but the humidification system is
not activated.
Cause
A scale calibration is attempted,
and there is >1 Kg on the bed
mattress.
A weighing function is initiated,
but the cable between the scale
and the sensor module is discon-
nected.
A weighing function is initiated,
but the cable between the scale
and the sensor module is broken.
The controller determines that
the weight placed on the scale is
more than the scale measure-
ment range.
Troubleshooting
Remedy
Install the servo control oxygen
system.
Set up the servo control oxygen
system in the system configura-
tion menu (see System configu-
ration menu on page 113).
Calibrate the oxygen sensor.
Slide the sensor module out to
the calibration position.
Remedy
Install the humidification system.
Set up the humidification system
in the system configuration menu
(see System configuration menu
on page 113).
Remedy
Remove all items from the bed
mattress.
Reconnect the cable between
the scale and the sensor module.
Remove the scale from service.
Remove excess weight.
127