Raven AutoBoom Installation Manual page 18

Chapter 3
Pressure and Tank Hoses Installed
FIGURE 9.
Disconnect the machine's pressure hose from port P on the machine's hydraulic valve.
1.
Connect the machine's pressure hose to the straight end of the installed tee fitting in port 1 of the logic valve
2.
(P/N 334-0003-075).
Install the straight end of the supplied hydraulic hose (P/N 214-1000-389) to the 90° end of the installed tee
3.
fitting.
Connect the 90° end of the installed hydraulic hose to Port P of the AutoBoom valve.
4.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-644) to the machine's pressure port.
5.
Connect the 90° end of the installed hydraulic hose to the installed fitting in port 2 of the logic valve.
6.
Disconnect the machine's return hose from the return port on the machine's hydraulic valve.
7.
Install a 9/16" JIC M/M/F swivel run tee adapter fitting (P/N 333-0012-043) in the return port of the
8.
machine's hydraulic valve.
Connect the machine's return hose to the straight end of the installed tee fitting.
9.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-389) on the 90° end of the installed tee
10.
fitting.
Connect the 90° end of the installed hydraulic hose to the installed fitting in the Left T Port of the AutoBoom
11.
valve.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-643) to the installed fitting in port 3 of
12.
the logic valve.
Connect the 90° end of the installed hydraulic hose to the fitting installed in Port LSP of the AutoBoom
13.
valve.
14
CAUTION
When installing AutoBoom hydraulics or
performing diagnostics, maintenance, or routine
service, ensure precautions are taken to
prevent any foreign material from being
introduced into the machine's hydraulic system.
Objects or materials that are able to bypass the
machine's hydraulic filtration system will reduce
performance and possibly cause damage to the
AutoBoom hydraulic valve.
GVM Predator (2007 & Older) AutoBoom Installation Manual