Gastroback Design Tea & More Advanced Operating Instructions Manual page 77

Problem Reason
The set temperature is equal or
lower than the actual water tem-
perature within the kettle.
You have program- To avoid unintended changes to
med your own the programmed data, the appli-
settings but your ance will only save the current
program is not kept settings, after it has been started
in memory. with these values.
Only some programs keep your
settings.
Only the "Custom" program will
save your own data and keep
them even after shut off.
The appliance does After reaching the set temperature,
not keep to your with the tea programs and the
selected cooking "Custom" program, the appliance
time. waits for you to press the "Start/
Stop" button. If you don't do so,
the program will be cancelled after
10 minutes.
The water has an This may happen on new appli-
unpleasant taste of ances or appliances that are used
plastic. only rarely.
Water accumulates
There is too much water in the
under the power kettle.
base or runs down
on the exterior of
the kettle.
You spilled some water when fil-
ling or moving the kettle.
The Solution
The set temperature must be higher (at least 5°C)
than the actual temperature within the kettle to
start a program. Wait until the kettle cooled down
sufficiently or select a somewhat higher tempe-
rature.
To save your program, start the program by pres-
sing the "Start/Stop" button. Thereafter, if you do
not wish to run the program, you may cancel ope-
ration immediately by holding the "Start/Stop"
button pressed for 3 seconds.
Select an appropriate program (see: 'Properties of
Your New Tea & More').
Shortly press the "Start/Stop" button, when the
set temperature is reached an the "Start/Stop"
button is flashing. This will make the appliance to
continue operation according to the set values.
Prepare the appliance for usage as described in
chapter 'Before First Use'. If the problem persists,
fill the kettle with 1.5 litres of water and add two
teaspoons of soda. Bring the water to the boil.
Then discard the water and clean the kettle tho-
roughly.
Immediately unplug the appliance. Then wipe
dry the appliance completely. Always observe the
maximum filling level when filling (see: 'Technical
Specifications').
Immediately unplug the appliance. Then wipe dry
the appliance completely. Ensure not to spill water
on the exterior of the kettle during filling. Always
ensure to hold the kettle level when it is filled.
77