Resetting To Factory Settings - Gastroback Design Tea & More Advanced Operating Instructions Manual

kettle. Close the opening of the lid ring via the appropriate stainless steel lid.
6. Press the "Hot water/Cooking" button repeatedly until "Baby" is shown at the
lowest line of the display. The pre-defined operating time of 2½ minutes is indi-
cated on the display ("2m30s"). There is no need for any further entry.
7. Press the "Start/Stop" button to start the program. When warming up mash, you
should stir the food within the glass insert several times to get an even result.
When the pre-set water temperature in the kettle (55°C) is reached, the war-
ming up time ("Steeping") starts, displayed as a count-down. After 2½ minutes
a signal sounds and the display shows "End".
8. Check the temperature of your food. If the food has not reached the desired
temperature, just leave the glass insert within the kettle. For your assistance, after
each 40 seconds, a beep will sound.
Tip: To keep your workspace dry, you should keep the provided stainless steel
bowl or another sufficient coaster for placing the glass insert on it.
9. Grasp the lid ring at both handles and lift the lid ring including the glass insert
out of the kettle. Carefully place the glass insert on the stainless steel bowl or
coaster and lay down the lid ring. Now you can grasp the glass insert easily
for taking out your food.
Important: Before feeding, always check the temperature of the food.
10. Stir the food and check the temperature before feeding.
Note
The water within the kettle will stay warm for some time after heating. If you wish
to keep your food warm, simply place the glass insert back into the kettle.
11. After usage, cancel the program by holding the "Start/Stop" button pressed for
3 seconds.
12. You should discard the water within the kettle to avoid excessive build-up of
scale on the heating plate. Unplug the appliance.

RESETTING TO FACTORY SETTINGS

When making your individual changes to the pre-programmed settings of the
"Custom" program, the appliance will keep your settings in memory—even after shut
off and disconnecting the appliance from the mains power supply. However, you
may wish to restore the pre-programmed factory settings. For this, proceed accor-
ding to the following steps.
75