Reparing The Appliance For Operation - Gastroback Design Tea & More Advanced Operating Instructions Manual

If water runs out during operation, immediately unplug the appliance (see: 'Solving
Problems').
Ensure to place the appliance on a level, flat, stable, and dry surface. Do not place
the appliance near the edge of the working space or on inclined surfaces. Do not
operate the appliance in a tray or tub or on a metal surface to avoid high risk of
electric shock, when overflow or splashing of hot water occurs. To avoid overhea-
ting, before operation, always fill a sufficient amount of clear drinking water into the
kettle (at least 500 ml/MIN). Do not operate the appliance with the kettle empty.
Always remove the kettle from the base and wait until the kettle cooled down,
before filling the kettle anew. For adding water while a cooking program is run-
ning, always pour the cold water into the middle of the kettle. For this, take out the
glass insert first. Do not leave cold water run down the side walls of the kettle, it
the kettle is hot.
Do not fill in more than the maximum amount (see: 'Technical Specifications'). If the
kettle is overfilled, boiling water may splash out. For moving the kettle, always ensu-
re to hold the kettle level, when it is filled. Regularly de-scale the kettle (see: 'Care
and Cleaning').
Important: The maximum water temperature of the keep warm function is limited to
90 - 95°C, because water will vaporize too quickly when kept at boiling tempera-
ture. Thus, the water level could fall easily below the minimum amount of 500 ml.
Note
Directly after the "Heating" phase, the actual water temperature within the kettle
could rise above the set temperature. Take this into account especially when using
only little amounts of water in the kettle and setting low temperatures.

REPARING THE APPLIANCE FOR OPERATION

WARNING:
any food or beverages within the kettle. There may be no cracks and chipped
edges. Even small splinters could cause severe injuries when getting into your food
or beverages.
1. Place the power base on the designated working place near an appropriate
wall power outlet (see: 'General Safety Instructions' and 'Important Safeguards
for Electrical Appliances').
2. Remove the kettle from the power base and remove the lid from the kettle.
3. Fill the desired amount of clear drinking water into the kettle. Ensure that the fil-
Always ensure that glass kettle is undamaged, before preparing
63