Reassembly - Suzuki VZR1800 2007 Service Manual

4-8 DRIVELINE/AXLE

REASSEMBLY

• Reassemble the secondary driven gear in the reverse order of
disassembly.
• The following steps require special attention or precautionary
measures should be taken.
BEARING AND OIL SEAL HOUSING
• Install the bearing with the special tool.
# 09913-70210: Bearing installer set (68 mm)
NOTE:
When installing the bearing, stamped mark on the bearing must
face outside.
• Install the bearing with the special tool.
# 09913-70210: Bearing installer set (42 mm)
NOTE:
When installing the bearing, stamped mark on the bearing must
face outside.
• Apply SUZUKI BOND to the mating surface of the bearing
housing and oil seal housing.
& 99000-31140: SUZUKI BOND "1207B" or equivalent
NOTE:
* Make surfaces free from moisture, oil, dust and other foreign
materials.
* Take extreme care not to apply any BOND to the bearing.
DRIVEN GEAR STOPPER
• Install the driven gear stopper with the special tool.
# 09913-70210: Bearing installer set (52 mm)
NOTE:
The chamter side A of driven gear stopper faces to the bearing.