Initial Operation; Connections - Agilent Technologies 1220 Infinity II LC Series User Manual

5. INITIAL OPERATION

5.1. Connections

Connect the cooling module with the Agilent 1220 Infinity System and the PC using patch
cables (see also Fig. 2 and Tab. 1 LAN).
Then use the power supply cable for the electrical connection. If you use a stand-alone
software (OPT023), connect the cooling module with the LC system by using the APG
remote cable.
Fig. 2 Connections
Tab. 1 Connections
Connection
LAN
USB Port
APG Remote
Inlet Cooling Water
User Manual SIM Sample Cooler_06/2018
Action
connect the cooling module through LAN with the LC system
(upper LAN port) as well as with the PC or laboratory network
(lower LAN port)
currently not in function, developed for future use
combined with the stand-alone software this port is used for
connection of cooling module and APG remote cable (for "Ready"
message)
For trained personnel only!
Use the syringe to fill/ refill the water tank and then lock it with
the blind plug and the security bar (see chapter 7.2)
Scientific Instruments Manufacturer GmbH
D-Oberhausen ● +49 (0)208/ 94 10 78-0 ● www.sim-gmbh.de
11