Table of Contents
Advertisement
5.3.3. Software settings for OPT023 (Standalone Software)
When the standalone software for the Sample Cooler is open, you can enter the temperature
requested into the field Temperature and confirm the value with S
Fig. 6
Software settings OPT023
Further buttons:
Tab. 2
Display
Display
Definition
Left – temporary information about connection to cooling module
Status bar
Right – status message of the cooling module
Find the related IP address (see log window "found new device at IP
Discover
10.43.43.220", red marking in Fig. 6)
Connect the software and cooling module
Connect
Select the "Ready" conditions for the APG Remote port (see next page)
Config
Set the desired temperature, from 5 to 40 ⁰C, in 1 ⁰C increments
Temperature
22
Scientific Instruments Manufacturer GmbH
D-Oberhausen ● +49 (0)208/ 94 10 78-0 ● www.sim-gmbh.de
.
ET
User Manual SIM Sample Cooler_06/2018
Advertisement
Table of Contents
