安装远程接口控制器（有线 - Wine Guardian WG15 Installation, Operation And Maintenance Manual

安装远程接口控制器（有线）
图 1
图 2
图 3
图 4
图 5
57
1. Disconnect the
the Wine Guardian unit and the remote interface controller. (Fig. 1)
1.
从 酒 卫 装
断开通信电缆。 （图 1）
a. Route the communication cable within the wall
and/or ceiling structure of the wine cellar to the desired controller
mounting location.
a. 在墙内
和/或酒窖的吊顶结构上计划安装控制器的位置布设通信电缆。
b. Plan on mounting the remote interface controller on a solid
surface away from doors, corners, air outlets, drafts or heat
generating equipment. Do not mount the remote interface
controller directly on an outside wall, a wall adjacent to a
boiler room, or other hot area. Use a piece of foam
insulation behind the sensor to insulate it from a hot or cold
surface. The recommended height is four to five feet above
the finished floor.
b.
请计划将远程接口控制器安装在远离门、角落、出风口、通风或
发热设备的固体表面上。请勿将远程接口控制器直接安装在外墙、
邻近锅炉房的墙壁或其他高温区域内。请在传感器后面使用一块泡
沫绝缘材料将其与热表面或冷表面隔离。建议高度为竣工地面以上
4 至 5 英尺。
2. Remove the back plate of the controller (Fig. 2) by removing two (2)
screws that hold it in place on the remote interface. Place the back plate
against the wall and mark the location of the two mounting points (Fig. 3).
Also mark the location of the penetration for the communication cable as
this area will require sufficient clearance for the cable to exit the wall and
attach to the back of the controller.
2. 卸下将控制器背板固定在远程接口上的两（2）个螺钉，从而卸下控制器背
板（图 2） 。将背板靠墙放置，并标记两个安装点的位置（图 3） 。同时标记通
信电缆的穿透位置（因为该区域需要足够的间隙以使电缆隔开墙壁并附着到控
制器的背面） 。
3. Drill two one-eighth inch holes and insert anchors at the marked
locations. Anchors may not be required if securing to a wall stud or racking
system. Insert the screws into the holes and test fit the backing plate to
ensure it mounts easily onto the two screws and slides down onto the slotted
opening freely (Fig. 4).
3. 在标记位置钻两个八分之一英寸的孔并插入锚。如果是固定在墙柱或支架系
统上，可能不需要锚。将螺钉插入孔中，并测试安装背板，以确保其可以很容
易安装到两个螺钉上，并可顺利滑入开槽开口（图 4） 。
communication cable
置 和 远 程 接
from the side
口 控 制 器 一
of
侧