Wine Guardian WG15 Installation, Operation And Maintenance Manual page 66

图 3
图 4
图 5
62
4. Drill two one-eighth inch holes and insert anchors within the
mounting surface. Anchors may not be required if securing to a
wall stud or racking system. Insert the screws into the holes and
test fit the backing plate for mounting to ensure it mounts easily
onto the two screws and slides down onto the slotted openings
freely. (Fig. 3)
4. 在安装面上钻两个八分之一英寸的孔并插入锚。如果是
固定在墙柱或支架系统上，可能不需要锚。将螺钉插入孔
中，并测试安装背板，以确保其可以很容易安装到两个螺
钉上，并可顺利滑入开槽开口。 （图 3）
5. Plug in the communication cable to the remote
sensor and mount the Remote Sensor to the wall. (Fig. 3)
5. 将通信电缆插入遥感器并将遥感器安装到墙上。 （图 3）
6. Reattach the sensor's faceplate (Fig. 4)
6. 重新固定传感器面板（图 4）
7. If multiple sensors are being used either connect each Sensor
to each other in series using RJ9 cable or purchase a RJ9 Splitter
(Fig. 5) to be connected to the unit.
7. 如果使用多个传感器，请使用 RJ-9 电缆将每个传感器串
联起来，或购买一个 RJ-9 分路器
（图 5）以与装置相连。
NOTE: Remote Sensor's will always be treated as "enabled"
when hardwired. Their temperature and humidity readings will
always be calculated towards the average by the system.
注意：
硬连线时，遥感器须始终处于"启动"状态。其温度和湿度读
数始终由系统按平均值计算。