Wine Guardian WG15 Installation, Operation And Maintenance Manual page 52

差温调节
Differential
temperature
adjustment
温度死区
Temperature
deadband
冷凝开关
Condensate switch
48
设置 15

按下"设置"按钮进入设置 15。

按"向上"或"向下"箭头按钮以调整到所需的设
定点。该设置将系统/压缩机开启温度更改为
高于设定值。出厂默认值为 1°F。
示例：传感器读数 = 55°F (13°C)
设置 17 设置为+3°F
系统/压缩机启动温度为 58°F (14°C)
Setting 15

Press "Settings" button to advance to Setting 15

Press the "Up" or "Down" buttons to adjust to
the desired setpoint. This setting changes the
system/compressor turn-on temperature above
setpoint. Factory default is 1°F.
Example: Sensor reading = 55°F (13°C)
Setting 17 set to +3°F
System/compressor turns on at 58°F (14°C)
设置 16

按下"设置"按钮进入设置 16。

按"向上"或"向下"箭头按钮以调整到所需的设
定点。此设置是加热和冷却设定点之间的最
小允许温差。最大为 5°F (3°C)，最小为 1°F
(1°C)。出厂默认温度为 2°F (1°C)。
Setting 16

Press "Settings" button to advance to
Setting 16.

Press the "Up" or "Down" buttons to adjust
to the desired setpoint. This setting is the
minimal allowable temperature difference
between heating and cooling setpoints.
Maximum is 5°F (3°C), minimum is 1°F
(1°C). Factory default is 2°F (1°C).
设置 17

按下"设置"按钮进入设置 17。

按"向上"或"向下"箭头按钮以调整到所需的设
定点。该设置禁用或启用冷凝开关。0（零）
为禁用，1 为启用。出厂默认值为 0。
Setting 17

Press "Settings" button to advance to Setting 17.
Press the "Up" or "Down" buttons to adjust to the
desired setpoint. This setting disables or enables
the Condensate switch. 0 (zero) is disabled, 1 is
enabled. Factory default is 0.