Wine Guardian WG15 Installation, Operation And Maintenance Manual page 44

箭头来调整设置。一次按"设置"按钮将进入下一个配置设置。在配置模式下按住
SETTINGS 按钮 5 秒钟将存储所有更改并退出配置模式。
SETTINGS – The setting button will be used to select between HEAT, COOL and AUTO
MODE, as well as entering the configuration settings. Holding the SETTINGS button for 5
seconds will enter configuration mode. Once in configuration mode the user can adjust settings by
pressing the UP or DOWN arrows. Pressing the SETTINGS button once will advance to the next
configuration settings. Holding the SETTINGS button for 5 seconds while in configuration mode
will store all changes and exit configuration mode.
仅用于制冷操作：60Hz 型号的冷却出厂设置为 55°F，50Hz 型号的冷却设置为 13°C。可以
通过按 UP 或 DOWN 箭头更改此设置，但是与高温警报设置和低温警报设置相比，请参考
配置设置 2 和 3，以了解限制。
For cooling operation only: Cooling for 60Hz models is set at 55°F from the factory and 13°C
for 50Hz models. This can be changed by hitting the UP or DOWN arrow, but please refer to
configuration settings # 2 and # 3 for limitations in comparison to the High and Low temperature
alarm settings.
对于带有由 TTW WG 控制的可选加湿器的设备：RH％出厂设置为 55％。可以通过参考配
置设置 6 来更改此设置。如果未连接加湿器，则控件将读取 RH％，但不会对其进行控制
。
For units with optional humidifier controlled by TTW WG: The RH% is factory set at 55%.
This can be changed by referring to configurations setting # 6. If no humidifier is attached, the
control will read RH%, but will not be controlling it.
更改风扇操作：出厂默认设置为" AUTO"风扇。如果需要，可以通过访问配置设置＃7 将
其更改为"打开"风扇。
Changing fan operation: The default setting from the factory is "AUTO" fan. If desired it can
be changed to fan "ON" by accessing configuration setting # 7.
40