English - Wine Guardian Sentinel Series Quick Start Installation Manual

1.Pre-Install Start Up
A. Remove unit from box. Check for any signs of
concealed damage, and that all optional equip-
ment has been provided. Contact Wine Guardian
immediately if components are missing or unit has
been damaged in shipping.
B. Connect thermostat and cable to unit.
C. Plug unit into outlet and turn ON/OFF switch to
"ON." The system will turn on after a 5-minute time
delay and the cold air section will start to deliver
cold air. Contact Wine Guardian if the system fails
to turn on.
2. Installation Location
A. Wine Guardian system must be mounted hori-
zontally on its base as shown and be level to
+/- 1/4" (0.6 cm) end to end and 1/8" (0.3 cm)
side to side.
B. Mount unit in a location that is easily accessible
for service and allow at least 3 feet (1 meter) for
clearance on either side of the system for mainte-
nance.
C. Mount the system on the floor on an elevated plat-
form at least 8" (20 cm) high. Unit can also be
ceiling mounted or wall mounted by creating a
platform to support the unit base.
3. Installing Thermostat (Wired)
A. Unit is supplied with 50 feet (15 meters) of ca-
ble with RJ-9 type connection along with the
Remote User Interface Controller.
B. Locate the Remote User Interface within the
room midpoint on a wall in an area with good
airflow and away from any windows or heat
sources.
C. Disconnect the wire from the back of the control-
ler and route the cable to the desired mounting
location within the room.
D. Provide a 3/4" (19 mm) diameter hole within the
wall or racking structure to provide clearance for
routing of the RJ-9 connection at the back of the
controller.
3