Wine Guardian WG15 Installation, Operation And Maintenance Manual page 69

65
NOTE: Check what RF Channel the System is set to using Setting 31 to more
easily connect your Remote Sensors.
31
注意：使用设置 检查系统设置的
a. Use a pin to press the red button at the back of the Remote Sensor for 5 seconds
until the LED blinks rapidly then release the button.
a. 使用别针按下遥感器背面的红色按钮 5 秒钟，直至 LED 快速闪烁，然后松开按
钮。
b. The LED will flash a number of times to portray which RF channel it is set to and
repeat a total of 3 times.
b. LED 将闪烁多次，以说明其设置为哪个射频通道，并重复 3 次。
c. To change the RF channel, press the button once to increment the RF channel. There
are 12 possible RF channels. All Remote Sensors will need to be on the same channel
for the system to detect them. To save the RF channel setting simply wait for the
mode to time out by not pressing the button.
c. 要更改 RF 频道，请按一下按钮以增加 RF 频道。有 12 个 RF 频道可供选择。
所有遥感器必须处于同一频道，系统才能检测到它们。如要保存 RF 频道设置，
只需松开按钮，等待模式超时即可。
RF
频道，以便更轻松地连接遥感器。