Wine Guardian WG15 Installation, Operation And Maintenance Manual page 19

Internal Drain – Condensate from the evaporator coil is directed to the condensate removal system at the
condenser end of the unit. This allows the drain pan to drain freely. No external trap is required.
制冷剂回路： 由生产厂家安装的制冷剂回路由毛细管网、过滤干燥器以及手动重置式高压开关组成。请
见第 22 页的图示。
Refrigerant Circuit – The factory-charged circuit includes a capillary tube expansion device, a filter dryer, and a
manual reset high pressure switch. See Refrigeration Illustration on page 10.
/ 网格由坚固的 ABS 塑料制成，已由厂家安装完毕，固定在底座上。空气将通过设备两侧
送风 回风网格：
及底部送入，并由前部排出。
Supply/return grilles – These are made of rugged ABS plastic and factory mounted to automatically seal to the
chassis. Air is introduced through the sides and bottom and discharged through the front perforated section.
活动式百叶窗：
蒸发器送气口处安装有两扇活动式百叶窗，在拆除酒窖一面的盖板后即可看到。您可以
通过手动调节百叶窗来决定空气流向。在本设备安装在酒窖角落中时，冷空气也可通过百叶窗直接到达
房间中心。
Directional Louvers – Two directional louvers are located within the evaporator supply air dis- charge opening
on the Wine Guardian unit and can be accessed by removal of the wine cellar side faceplate. The louvers are
designed to be manually adjusted to direct air flow from side-to- side or straight on. The louvers can help direct
cold air into the center of the wine cellar should the Through-the-Wall unit be mounted in a corner of the room.
15