Table of Contents
Advertisement
Operating instructions
4.1.2 Preparations before filling
4.1.3 Filling and heating the machine
Check:
•
That the machine and removable parts have been cleaned. If not – clean
them!
•
That there is no dirt in the wash arm (17, 18) or rinse pipe nozzles (20, 21)
•
That removable parts are correctly in place
•
Amount of detergent and drying agent (option)
•
That the stopcock for the water to the machine is open
•
That the main switch is in the ON position
Remember:
•
Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable deter-
gent. Washing-up liquid causes a build-up of foam, produces poor wash re-
sults and can damage the machine.
•
Steel wool must not be used for pre-treating the dishware.
•
Only detergent and drying agent intended for industrial machines may be
used.
•
If using liquid detergent and drying agent, the same make and type of de-
tergent and drying agent should be used.
•
The doors (14) must be closed.
•
Press button (12) to switch on the power supply.
•
Press button (6). The filling and heating process will begin.
•
Press button (8) to activate the washing conveyor feed when the following
text is shown in the display:
THE MACHINE IS READY
TO WASH
START THE FEED
USING THE FEED BUTTON
N.B.: The time it takes for the machine to fill and heat up to the right washing tem-
perature varies between 5 and 30 minutes, and depends on the temperature of
the incoming water.
WD-ACS 47D
21
Rev. 1.0 (202003)
Advertisement
Table of Contents
