Table of Contents
Advertisement
Operating instructions
4.2.5 Changing the water
4.3 After use – Cleaning
N.B.: The water in the wash tank must be changed regularly, otherwise foam will
start to form and the washing results will deteriorate. If the filters are clogged with
foam or if foam comes out of the waste pipe, the water must be changed imme-
diately.
For best wash results, it is important that the water in the tanks is changed when
it becomes too dirty. The water should always be changed if foam begins to form
in the washing tanks.
•
Switch off the machine using button (12).
•
Remove the filters (30, 32) and empty the tanks by turning the level pipe
(31) and drain seal (27) a quarter of a turn.
•
When the tanks are empty, refit the level pipe (31) and outlet seal (27).
•
Refit the strainers (30, 32).
•
Refill the machine. See "Filling and heating the machine".
Automatic emptying of wash tanks (option)
•
Automatic emptying of wash tank 1 will start when the pushbutton (33) next
to the control panel is pressed. Wash tank 02 and the final rinse tank will
be emptied when pushbutton (34) is pressed.
•
Refill the machine. See "Filling and heating the machine".
HACCP is a preventive inspection system to ensure hygiene requirements are
met during the washing process and cleaning of the machine. As a result of its
design, the machine meets strict hygiene requirements. Regular, thorough clean-
ing is also important from a hygiene perspective. A machine that is properly
cleaned helps produce a good wash result, reduces the risk of dirt accumulating,
increases the service life of the machine and reduces the risk of emergency shut-
down.
The machine is easiest to clean while it is still warm.
WD-ACS 47D
24
Rev. 1.0 (202003)
Advertisement
Table of Contents
