Advertisement
Quick Links
Advertisement
Related Manuals for Raven SmarTrax Spra-Coupe 220
Summary of Contents for Raven SmarTrax Spra-Coupe 220
- Page 1 SmarTrax™ Installation Manual Spra-Coupe 220...
- Page 2 GPS satellites, the OmniSTAR correction service or the WAAS correction service. Raven Industries accepts no responsibility for the use of the signal for other than the stated purpose. Raven Industries shall not be responsible or liable for incidental or consequential damages or a loss of anticipated benefits or profits, work stoppage or loss or impairment of data arising out of the use, or inability to use, the SmarTrax or any of its components.
-
Page 3: Table Of Contents
016-0190-058 TABLE OF CONTENTS 03/05 MOUNTING HYDRAULIC VALVE AND BRACKET ................2 INSTALLING PRESSURE, TANK, EXCESS FLOW, LEFT AND RIGHT STEER LINES ....3 INSTALLING STEERING POSITION SENSOR (S.P.S.) ..............4 CABLE ROUTING ..........................5 START-UP PROCEDURES ........................ 5... -
Page 4: Mounting Hydraulic Valve And Bracket
Holes are marked then drilled, and provided 3/8” bolts are used to fasten mounting bracket to frame rail. Raven valve is then attached to mounting bracket using provided bolts. Valve should be positioned so valve coil stack is pointing in a rearward direction. -
Page 5: Installing Pressure, Tank, Excess Flow, Left And Right Steer Lines
Original right steer hose is then connected to tee. Raven right steer hose is then connected to “B” port on Raven valve, to tee on right steer port of orbital. Left steer hose is disconnected from steer orbital, then #6 run tee is attached to orbital. -
Page 6: Installing Steering Position Sensor (S
MOUNTING STEERING POSITION SENSOR (S.P.S.) The SPS is mounted on right side of machine. One end is attached to tie rod as shown in picture, using provided clamps and mounting tab. Other end is attached to front axel near spindle, by welding mounting tab to machine as shown in picture. -
Page 7: Cable Routing
CABLE ROUTING Connect wire harness to left and right steering coils, SPS and pressure switch. Inner coil is right coil and outer coil is left coil. If steering is reversed, switch coil connections around. START-UP PROCEDURES Check S.P.S. stroke length to be sure it is not over compressed or over extended. Turn steering wheel full left and right to purge system of air. - Page 11 How Can I Get Service? Bring the defective part and proof of purchase to your Raven Dealer. If your Dealer agrees with the warranty claim, the Dealer will send the part and proof of purchase to their distributor or to Raven Industries for final approval.
- Page 12 P.O. Box 5107 Fax: 605-331-0426 Sioux Falls, SD 57117-5107 www.ravenprecision.com atdinfo@ravenind.com Notice: This document and the information provided are the property of Raven Industries, Inc. and may only be used as authorized by Raven Industries, Inc. All rights reserved under copyright laws.