Western Digital Ultrastar Data60 Installation Manual page 53

Installation Guide
Figure 24: Installing the Chassis
d. Once the rails are mated properly, slide the enclosure into the rack until it is stopped by the
safety catch on the rails. Push the release lever on the safety latch (located on the side of
each of the rails), and push the enclosure the rest of the way into the rack.
Figure 25: Safety Latch Release
e. As the chassis is slid into the rack, position one installer at the rear of the rack to ensure that
the pegs on the sides of the cover will slide correctly into the rear cover alignment brackets
on both sides of the rack. If the chassis does not install smoothly or snags, check that the
rear cover alignment brackets are not interfering with the chassis sidewalls, and try again.
Step 11 : Install the crossbar onto the CMA mounting bracket.
a. Align the crossbar with the mounting peg facing down and pointing toward the CMA
mounting bracket.
5.2 Ultrastar Data60 Installation Procedure
5. Installation
46