Festo CPV -GE-DN2-8 Electronic Manual page 66

2. Commissioning
2-14
Parametrizing slaves
1. Double-click on one of the slaves in the "Scanlist"
(Fig. 2/5). A mask will open.
2. Determine the I/O parameters of the slave. Confirm with
OK.
Fig. 2/6: Mask for determining the I/O parameters of the
slave
In this configuration example a CPV Direct with maximum
extension is parametrized:
– Communication type: "Polled" or "Strobed" (1 input byte
for diagnostic information).
– 2 input bytes for a CP input module in the extension.
– 4 output bytes for the CPV Direct and an output module
in the extension.
Observe the summary in Fig. 2/3.
Festo P.BE-CP-DN2-EN en 0107NH