Festo CPV -GE-DN2-8 Electronic Manual page 20

1. Installation
1-6
Removing
1. Switch off the operating voltage.
2. Unscrew the two fastening screws of the switch module.
3. Lift up and remove the switch module.
Fitting
1. Place the switch module carefully in the recess.
2. Tighten the two fastening screws alternately.
Please note
– Do not tilt the switch module when fitting it. The fitting
position is clearly marked by a groove in the housing.
– Make sure that the seal is seated correctly.
Festo P.BE-CP-DN2-EN en 0107NH